Visual weld inspection — qualified eyes on every joint.
Most weld defects can be detected visually if you know what to look for. Our qualified CWI-competent inspectors perform pre-weld, in-process and post-weld visual inspection to AWS D1.1, ASME IX and EN ISO 5817 acceptance criteria.
What we cover.
The complete range of equipment and procedures included in this service line.
Pre-Weld Inspection
Joint preparation, fit-up & cleanliness
In-Process Inspection
Pre-heat, inter-pass & bead check
Post-Weld Visual
Bead profile, undercut, cracks, spatter
Macro-Etch Examination
Cross-section etch on test welds
Code Compliance
AWS D1.1 / ASME IX / EN ISO 5817 review
Repair Inspection
Weld repair & rework verification
Codes & standards we work to.
Every certificate references the applicable code so you can audit every test back to its source.
Other Welding & Coating QC services from GCS.
Most clients combine two or more services for bundled pricing & faster mobilisation.
Coating Inspection
Protective coatings are only as good as their application. Our coating inspectors verify...
View pagePre Shipment Inspection
Catching defects at the supplier’s factory is far cheaper than catching them on site. We deliver pre-...
View pageWPS / PQR Review
Before a single production weld is laid down, the procedure must be qualified and the welder must be tested...
View page