Coating & paint inspection — accredited QC.
Protective coatings are only as good as their application. Our coating inspectors verify surface preparation, climatic conditions, dry film thickness (DFT), holiday detection and adhesion testing.
What we cover.
The complete range of equipment and procedures included in this service line.
Surface Prep Verification
Sa 2.5 / Sa 3 blast profile checks
Salt Contamination
Soluble salt & chloride testing
Climatic Conditions
Dew point, RH, surface temp logging
Dry Film Thickness
DFT per coat & total system check
Holiday Detection
Low & high voltage holiday testing
Adhesion Testing
Pull-off & cross-cut adhesion checks
Codes & standards we work to.
Every certificate references the applicable code so you can audit every test back to its source.
Other Welding & Coating QC services from GCS.
Most clients combine two or more services for bundled pricing & faster mobilisation.
Pre Shipment Inspection
Catching defects at the supplier’s factory is far cheaper than catching them on site. We deliver pre-...
View pageVisual Weld
Most weld defects can be detected visually if you know what to look for. Our qualified CWI-competent inspec...
View pageWPS / PQR Review
Before a single production weld is laid down, the procedure must be qualified and the welder must be tested...
View page